---

Section I.Chemical Product and Company Identification
    Chemical Name 4-(2-Aminoethyl)-1-benzylpiperidine
    Portland OR
    Synonym        4-Piperidineethanamine, 1-(phenylmethyl)-(9CI)    
    Chemical Formula        C14H22N2    
    CAS Number        86945-25-7    

---

Section II.        Composition and Information on Ingredients    
    Chemical Name        CAS Number Percent (%)        TLV/PEL        Toxicology Data    
    4-(2-Aminoethyl)-1-benzylpiperidine        86945-25-7        --------- Not available.        Not available.    

---

Section III. Hazards Identification
    Acute Health Effects        Irritating to eyes and skin on contact. Inhalation causes irritation of the lungs and respiratory system. Inflammation of the    
    eye is characterized by redness, watering, and itching. Skin inflammation is characterized by itching, scaling, reddening,
    or, occasionally, blistering. Follow safe industrial hygiene practices and always wear proper protective equipment when
    handling this compound.
    CARCINOGENIC EFFECTS : Not available.
    Chronic Health Effects
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    There is no known effect from chronic exposure to this product. Repeated or prolonged exposure to this compound is
    not known to aggravate existing medical conditions.

---

Section IV.        First Aid Measures    
    Eye Contact        Check for and remove any contact lenses. IMMEDIATELY flush eyes with runing water for at least 15 minutes. keeping    
    eyelids open. COLD water may be used. DO NOT use an eye oitment. Flush eyes with running water for a minimum of
    15 minutes, occasionally lifting the upper eyelids. Seek medical attention. Treat symptomatically and supportively.
    Skin Contact        After contact with skin, wash immediately with plenty of water. Gently and thorough wash the contaminated skin with    
    running water and non-abrasive soap. Be particularly careful to clean folds, crevices, creases and groin. COLD water
    may be used. Cover the irritated skin with an emollient. Seek medical attention. Treat symptomatically and supportively.
    Wash any contaminated clothing before reusing.
    Inhalation        If the victim is not breathing, perform artificial respiration. Loosen tight clothing such as a collar, tie, belt or waistband. If    
    breathing is difficult, oxygen can be administered. Seek medical attention. Treat symptomatically and supportively.
    Ingestion        INDUCE VOMITING by sticking finger in throat. Lower the head so that the vomit will not reenter the mouth and throat.    
    Loosen tight clothing such as a collar, tie, belt, or waistband. If the victim is not breathing, administer artificial respiration.
    Examine the lips and mouth to ascertain whether the tissues are damaged, a possible indication that the toxic material
    was ingested; the absence of such signs, however, is not conclusive. Seek immediate medical attention and, if possible,
    show the chemical label. Treat symptomatically and supportively.

---

Section V.        Fire and Explosion Data    
    Auto-Ignition        Not available.    
    Flammability        May be combustible at high temperature.    
    Flash Points        Flammable Limits        Not available.    
    Not available.
    Combustion Products        These products include toxic carbon oxides (CO,CO 2), nitrogen oxides (NOx).    
    Fire Hazards
    No specific information is available regarding the flammability of this compound in the presence of various materials.
    Explosion Hazards        Risks of explosion of the product in presence of mechanical impact: Not available.    
    Risks of explosion of the product in presence of static discharge: Not available.
    No additional information is available regarding the risks of explosion.
    Fire Fighting Media
    SMALL FIRE: Use DRY chemicals, CO 2, water spray or foam.
    and Instructions        LARGE FIRE: Use water spray, fog or foam. DO NOT use water jet.    
    Continued on Next Page
    4-(2-Aminoethyl)-1-benzylpiperidine

---

Section VI.        Accidental Release Measures    
    Spill Cleanup        Irritating material.    
    Instructions        In case of a spill and/or a leak, always shut off any sources of ignition, ventilate the area, and exercise caution. Absorb    
    with an inert material and put the spilled material in an appropriate waste disposal. Finish cleaning the spill by rinsing any
    contaminated surfaces with copious amounts of water. Consult federal, state, and/or local authorities for assistance on
    disposal.

---

Section VII. Handling and Storage
    IRRITANT. Keep away from heat and sources of ignition. Mechanical exhaust required. When not in use, tightly seal the
    Handling and Storage
    container and store in a dry, cool place. Avoid excessive heat and light. Do not breathe gas, fumes, vapor or spray.
    Information
    Always store away from incompatible compounds such as oxidizing agents.

---

Section VIII. Exposure Controls/Personal Protection
    Engineering Controls        Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapors below their    
    respective threshold limit value. Ensure that eyewash station and safety shower is proximal to the work-station location.
    Splash goggles. Lab coat. Vapor respirator. Boots. Gloves. Be sure to use a MSHA/NIOSH approved respirator or
    Personal Protection
    equivalent. Suggested protective clothing might not be sufficient; consult a specialist BEFORE handling this product.
    Exposure Limits        Not available.    

---

Section IX. Physical and Chemical Properties
    Physical state @ 20°C        Colorless clear liquid.        Solubility    
    Not available.
    Not available.
    Specific Gravity
    Molecular Weight        218.34        Partition Coefficient    
    Not available.
    Boiling Point        Not available.        Vapor Pressure        Not available.    
    Melting Point        Not available.        Vapor Density        Not available.    
    Not available.        Not available.    
    Refractive Index        Volatility    
    Critical Temperature        Not available.        Odor        Not available.    
    Viscosity        Not available.        Taste        Not available.    

---

Section X.        Stability and Reactivity Data    
    Stability    

---

This material is stable if stored under proper conditions. (See Section VII for instructions)    
    Conditions of Instability
    Avoid excessive heat and light.
    Incompatibilities
    Reactive with oxidizing agents.

---

Section XI. Toxicological Information
    RTECS Number        Not available.    
    Routes of Exposure        Eye contact. Ingestion. Inhalation.    
    Not available.
    Toxicity Data
    CARCINOGENIC EFFECTS : Not available.
    Chronic Toxic Effects
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    There is no known effect from chronic exposure to this product. Repeated or prolonged exposure to this compound is not
    known to aggravate existing medical conditions.
    Acute Toxic Effects        Irritating to eyes and skin on contact. Inhalation causes irritation of the lungs and respiratory system. Inflammation of the    
    eye is characterized by redness, watering, and itching. Skin inflammation is characterized by itching, scaling, reddening,
    or, occasionally, blistering. Follow safe industrial hygiene practices and always wear proper protective equipment when
    handling this compound.
    Continued on Next Page
    4-(2-Aminoethyl)-1-benzylpiperidine

---

Section XII.        Ecological Information    
    Ecotoxicity        Not available.    
    Environmental Fate        Not available.    

---

Section XIII. Disposal Considerations
    Recycle to process, if possible. Consult your local or regional authorities. You may be able to dissolve or mix material with
    Waste Disposal
    a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber system. Observe all
    federal, state, and local regulations when disposing of the substance.

---

Section XIV. Transport Information
    DOT Classification        Not a DOT controlled material (United States).    
    PIN Number        Not applicable.    
    Proper Shipping Name
    Not applicable.
    Packing Group (PG)        Not applicable.    
    DOT Pictograms

---

Section XV. Other Regulatory Information and Pictograms
    TSCA Chemical Inventory        This product is NOT on the EPA Toxic Substances Control Act (TSCA) inventory. The following notices are required by 40    
    CFR 720.36 (C) for those products not on the inventory list:
    (EPA)
    (i) These products are supplied solely for use in research and development by or under the supervision of a technically
    qualified individual as defined in 40 CFR 720.0 et sec.
    (ii) The health risks of these products have not been fully determined. Any information that is or becomes available will be
    supplied on an MSDS sheet.
    WHMIS Classification        Not available.    
    (Canada)
    EINECS Number (EEC) Not available.
    EEC Risk Statements        R36/37/38- Irritating to eyes, respiratory system and skin.    

---

SECTION 16 - ADDITIONAL INFORMATION
N/A